Sandy, Utah
Commercial Roofing around Sandy
Low-slope and membrane systems for commercial buildings.
Commercial Roofing for Sandy homes and buildings
TPO, EPDM, PVC, modified bitumen and built-up, specified for the building and the traffic it takes.
The bench neighborhoods catch canyon wind coming down out of Little and Big Cottonwood, and it hits rake edges harder than open valley wind does.
A commercial roof is a different trade from a steep-slope house roof. We do both, separately.
What matters on commercial roofing
Drainage before material
The first question on any low-slope roof is where the water goes. Ponding is what kills membranes, and a roof that holds water for days after a storm will fail early regardless of which sheet is on it. We look at the slope, the drains and the terminations before we talk about material.
Seams and terminations
Field failures on commercial roofs are rare. Failures at seams, curbs, drains and the parapet edge are common. A hot-air welded seam that has been probed is a continuous sheet. Anything taped or glued and unverified is a scheduled leak.
Commercial Roofing around Sandy
How the system goes together
Coatings on a low-slope roof
A roof coating is a maintenance system, not a replacement. On a sound membrane or a metal roof with good fasteners, a properly prepped coating adds reflectivity and buys real years. Over a wet insulation layer or a membrane that has already delaminated, it is paint over a problem.
Prep is the whole job
Cleaning, seam treatment, and fixing what is actually broken take longer than rolling the coating on.
When coating is wrong
If a roof is done, coating it just delays the same conversation.
Bringing an old metal roof back
A metal roof with sound panels and a tired finish is usually a candidate for restoration rather than replacement. Every exposed screw gets pulled and replaced one size up with a fresh washer, the seams and penetrations get reinforced, and then a coating system goes over the whole assembly to seal the thousands of small fastener points at once.
It only works on sound steel
Where the panel has rusted through, or where water has been getting into the insulation below for years, there is nothing for a coating to hold onto and we will say so.
What we check
- Field condition and granule loss
- Valleys, ridges and every transition
- Penetrations and their flashing
- Gutter and fascia condition
What the job looks like
Get on the roof
We walk it rather than look from the drive, check the decking underfoot, the flashings and the ventilation, and photograph what we find before any number is discussed.
Show you what we saw
The photographs come back to you with a plain read of what the roof needs and, just as often, what it does not need yet.
Crew on site
The crews we hire work under Hancock’s direction, staged so landscaping and the drive are protected, working the detail in the order it is supposed to go on rather than the order that is quickest.
Leave it clean
Site cleared at the end of every day, a magnet run over the whole yard for nails at the finish, and the roof walked with you before we go.
Thermal shock on metal and flashing
Metal moves. On a sunny winter day a standing seam panel or a piece of valley metal can run a hundred degrees warmer than the air, then drop back after dark. That expansion and contraction happens every clear day of the year here. Panels have to be fastened so they can move, clips have to be right, and a valley has to be detailed to slide instead of being pinned tight at both ends.
Pinned metal tears its own holes
When movement is blocked, the fastener holes elongate and that becomes the leak path.
Hail does not always look like damage
Hail here can be pea sized and harmless or big enough to bruise a mat. A bruise is a soft spot where the granules are knocked loose and the fiberglass underneath is fractured. You cannot see it from the ground, and from a ladder you often have to feel for it with a thumb.
Soft metal tells the truth
Before we call a roof hit, we check the soft metals: vents, gutter aprons, the fins on a swamp cooler. Dents there are the honest record of what fell.
Where roofs go wrong
The shortcut we see most
A membrane laid over wet insulation because tearing off would have cost a day. The roof looks finished, the moisture stays underneath, and the sheet fails early from below.
What good looks like instead
Moisture surveyed, wet sections cut out and replaced, drainage corrected, then the membrane installed and its seams probed.
Signs worth a look
- Ponding water still standing two days after rain
- Seams that have lifted or opened at an edge
- Blisters or ridging across the field
- Interior staining near drains, curbs or the parapet
Part of our Salt Lake County work, out of Salt Lake City & surrounding counties. A full replacement carries our 10-year workmanship warranty.
What to expect
Scheduling around your operation
Most commercial work can be staged so the disruptive part happens when the building is quiet. Tear-off noise, crane or hoist time and material deliveries all get planned against your hours rather than ours.
What the roof survey covers
Before specifying anything we survey the existing assembly: slope and drainage, moisture in the insulation, the condition of seams and terminations, and how the roof is being used. A roof somebody walks on weekly needs a different answer from one nobody touches.
Documentation
Commercial and public work runs on records. We photograph the existing condition, the work in progress and the finished assembly, so there is a file rather than a recollection.
On a Sandy roof
Getting to Sandy
We walk a Sandy roof before quoting it rather than pricing it from a satellite image.
That proximity is most of what matters when weather moves through. Sandy sits in Salt Lake County, and we are on roofs across it regularly enough to know how the housing there was built.
Questions we get asked
Not the question you had? Call the shop and ask a person. We would rather talk it through than have you guess from a website.
(801) 382-8898Do you actually work in Sandy?
Regularly. Sandy is ordinary working territory for us, not an outlying job we take when it is quiet.
How fast can you get to Sandy after a storm?
We make the roof safe first, then come back and do the repair properly when conditions allow.
Will you tell me if I do not need a new roof?
Yes. Plenty of what we look at turns out to be a repair, and we say so. A roof with years left in it gets left alone, and you get the photographs either way.
How long does a roof replacement take?
Most houses in this valley are a one to two day job once the crew is on site. Steeper pitches, multiple layers to strip and complicated roofs with a lot of valleys take longer, and we tell you which yours is before we start.
Do you handle the insurance side?
On hail-damaged roofs, we work with your insurance to get the roof covered. We document the damage thoroughly with photographs, so the claim reflects what is actually on the roof.
Where Sandy sits on our map
Crews reach Sandy on the normal week, not as a special run.
Talk to Hancock
Commercial Roofing in Sandy
Call (801) 382-8898.